Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - harbor freight bandsaw feed rate
View Single Post
  #3 (permalink)  
Old 10-27-2004, 12:18 PM
cboy's Avatar
cboy cboy is offline
Member
 

Last journal entry: Finished
Last photo:
Join Date: Jan 2004
Location: Atwater, CA
Age: 69
Posts: 3,918
Wiki Edits: 0

Thanks: 0
Thanked 3 Times in 3 Posts
No smoke, no binding, the blade seem to be running true, and it is not that hot after I finish a cut. So actually I'm a little worried it's "wearing" not "cutting" through the metal. I'm cutting 2x3 rec. tubing, .125 wall, and I'm cutting it diagonally at a 30 degree angle. These cuts are taking an average of about 15 minutes each. Does that sound in the ballpark?
__________________
Always learning...and sharing what I've learned. The Scratch-Built Hot Rod.
Reply With Quote