Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - harbor freight bandsaw feed rate
View Single Post
  #11 (permalink)  
Old 10-28-2004, 06:33 PM
willys36@aol.com's Avatar
willys36@aol.com willys36@aol.com is offline
Hotrodders.com Moderator
 
Last wiki edit: How to rebuild a Rochester Quadrajet 4MV carbureto...
Last journal entry: How to change auto shift timing on 200R4
Last photo:
Join Date: May 2002
Location: Bakersfield
Posts: 8,376
Wiki Edits: 21

Thanks: 1
Thanked 4 Times in 4 Posts
Maybe you got a bad one. Mine has a run-out of about the thickness of the blade @ 5" above the bed. My experience is that I get very acceptable squareness in my cuts until my blade starts getting dull when it starts to travel severely in one direction.
Reply With Quote