Hot Rod Forum : Hotrodders Bulletin Board

Hot Rod Forum : Hotrodders Bulletin Board (http://www.hotrodders.com/forum/)
-   Engine (http://www.hotrodders.com/forum/engine/)
-   -   Which Head Gaskets? (http://www.hotrodders.com/forum/head-gaskets-182944.html)

65malibuSS 08-18-2010 10:35 AM

Which Head Gaskets?
 
i just wanna get some opinions on what head gaskets i should get,
the motor is a 350 bored .30 over (355cid), aluminum heads, 10.5:1 compression, naturally aspirated motor

i wanna keep it right at 10.5:1, part numbers or suggestions would be awesome thanks!

F-BIRD'88 08-18-2010 11:12 AM

You need to supply more information to determine the compression ratio.

If you make us guess, we charge extra.

piston dish dome valve relief volume

piston ,deck clearance at TDC

cylinder head chamber volume

head gasket volume or bore and thickness specs

bore ,, stroke

http://www.wheelspin.net/calc/calc2.html

65malibuSS 08-18-2010 01:38 PM

the pistons are flat top, 2-valve relief, the bore is 4.030 and stroke is 3.48, and 65cc

F-BIRD'88 08-18-2010 02:52 PM

You also need to know the piston/deck clearance at TDC
and the gasket bore diameter and thickness.

lmsport 08-18-2010 02:53 PM

FelPro 1010.


All times are GMT -6. The time now is 08:41 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.