Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - hello! I have an issue with my consew!
View Single Post
  #1 (permalink)  
Old 07-31-2013, 09:12 PM
memphis81 memphis81 is offline
Registered User
 
Join Date: Jul 2013
Posts: 2
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
hello! I have an issue with my consew!

Hello!

I am new to this site...I am hoping to learn from you guys!

My main concern right now is that I have a used Consew 206rb-5 that I got a few months ago, and I think I messed something up.

I've broken a few needles recently...I think I may have had it threaded incorrectly recently to get this problem...well now when the needle goes all the way down it hits some part it is not supposed to and will not run/breaks the needle! When I turn the hand crank by hand it is very hard to get it to go when the needle bar is at the very top and then the very bottom of its range....which btw I can only do this without a needle installed. If I have a needle in it will break. Did I mess up the timing? Do I just need to take it to a shop? I am really bumming right now!

Can anyone help?

Thanks!
Jennifer
Reply With Quote