Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - help with ford 400-2V
View Single Post
  #8 (permalink)  
Old 09-03-2002, 09:01 PM
willys36@aol.com's Avatar
willys36@aol.com willys36@aol.com is offline
Hotrodders.com Moderator
 
Last wiki edit: How to rebuild a Rochester Quadrajet 4MV carbureto...
Last journal entry: How to change auto shift timing on 200R4
Last photo:
Join Date: May 2002
Location: Bakersfield
Posts: 8,384
Wiki Edits: 21

Thanks: 1
Thanked 4 Times in 4 Posts
Post

I know about the certification tests. I have welder friends in the oil fields and we do a lot of steam injection oil recovery here so the welders need to be x-ray certified for all positions on SC80, J and K grades, and extra strong grades for steam service. Not as sexy as the stuff you are certified in but to get an x-ray weld lying on your back in a muddy ditch at mid-night when it is windy and 25deg takes a pretty good welder!

I'll stick w/ my two semesters of welding classes in jr. college and 30 yrs of goofing around in my shop thank you!

[ September 03, 2002: Message edited by: willys36@aol.com ]</p>
Reply With Quote