Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Holley Dominator flange pattern
View Single Post
  #10 (permalink)  
Old 01-03-2005, 12:34 AM
machgnr machgnr is offline
New Member
 
Last photo:
Join Date: Sep 2003
Location: St Louis, MO
Age: 50
Posts: 13
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
two 850 dp's ?

OK maybe I'm thinking too small. I've got a 406 with AFR stage 2 heads and will swap to a blower cam, unsure of which cam though. What cfm should I be looking for to feed a 6-71 on a 406? It's actually a street car that's went to the track and quickly evolving into a strip machine that's gonna be driven on the street too, if you know what I mean !! I've only got an 8 gallon fuel cell in the trunk so akly's out! ha. Should I be looking for a couple of 650's or 750's? I seen an ad somewhere today a guy had two 750's dyno'd for a blower and never used. He was going to something bigger. opinion? also some blower cam advise as well would be appreciated. I'm also calling Hilborn tomorrow (Monday) to ask about a pump, bypasses, etc to set up the injection. I'll weigh that cost to the carb route and see what that looks like.
Reply With Quote