Hot Rod Forum banner

Holley Power Valve

2K views 1 reply 2 participants last post by  dgcantrellsr 
#1 ·
A Holley Carb as 2 power valves? A primary & a secondary?

If on a cammed motor with but 8lbs of manifold vacuum, would the new 4.5 Power Valve be installed on the primary side?

When would the secondary-side Power valve be changed?

Sheesh! :drunk:
 
#2 ·
How is the motor being used? Drive, drag, etc.
If you got that low a vacuum at idle, change both, would be my recommendation.
If its drag, block both power valves and jet up 10 numbers to start with.




DENCOUCH said:
A Holley Carb as 2 power valves? A primary & a secondary?

If on a cammed motor with but 8lbs of manifold vacuum, would the new 4.5 Power Valve be installed on the primary side?

When would the secondary-side Power valve be changed?

Sheesh! :drunk:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top