Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - hommade A frame gantry crane. supplies?
View Single Post
  #6 (permalink)  
Old 04-26-2011, 10:29 AM
matt167 matt167 is online now
Member
 
Last wiki edit: Ford axle ratio codes
Last journal entry: Rear Suspension
Last photo:
Join Date: Aug 2005
Location: Prattsville
Posts: 6,268
Wiki Edits: 31

Thanks: 2
Thanked 41 Times in 40 Posts
Little ms paint sketck of what I have in mind.. only issue I think there might be is the cylinder not going down because the weight is offset, but I would think it would still go down, especially If I added a little angle to the cylinder and put it on the inside and had it go to the top support beam

This is shown at basically fully compressed.
Attached Images
File Type: bmp crane1.bmp (1.67 MB, 131 views)

Last edited by matt167; 04-26-2011 at 10:36 AM.
Reply With Quote