Hot Rod Forum : Hotrodders Bulletin Board

Hot Rod Forum : Hotrodders Bulletin Board (http://www.hotrodders.com/forum/)
-   Hotrodding Basics (http://www.hotrodders.com/forum/hotrodding-basics/)
-   -   horsepower estimate (http://www.hotrodders.com/forum/horsepower-estimate-213641.html)

teopro5 01-30-2012 07:47 PM

horsepower estimate
 
I am building a chevy .040 bored, 3.48 stroke, 6" rods, flat top je pistons with a +5.00 rating, i am using brodix spch2005 dirt heads...they are 67cc, have a 215cc intake runner, 2.08 intake, 1.60 exhaust, i am using a cam of 546 lift both int and exh, int duration of 248 @050, exh of 252 @050, a brodix hv1011 intake and a 650 cfm carb, any thoughts on the horsepower, and torque of this combe at up to 7600 rpm? i can run 110 octane fuel but most likely will mix it 50/50 with 94 octane the compression figures out at 10-10.5:1

American Muscle 01-31-2012 01:49 AM

ok ill be the first to ask. Wht kind of small block? 283,305,307,327,350,400.

teopro5 01-31-2012 06:48 AM

350 block so 356 cu in


All times are GMT -6. The time now is 12:06 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.