|
|
|
03-31-2006, 08:39 PM
|
||||||
|
||||||
|
How can i tell if my holley has power vave protection
I have a BBC with a Holley 750 #80508-1, model 4160 I think the power valves are leaking gas into the engine when the engine is turned off. I plan to by a renew kit next week, but how can i tell if it has the power valve protection. This is not a very old looking carb (i bought it used) so not sure if it has laying around for some time. I do not wish to spend the money, if this will just happen again. I may just switch to a Q-jet if i can not figure this out.
old Bill T 
|
|
03-31-2006, 09:00 PM
|
||||||
|
||||||
|
As far as I can tell it does have the power valve protection. http://www.holley.com/0-80508S.asp
You may have to lower your float level a bit. The pressure may be overpowering the needle and seat allowing fuel to seep by. I really don't think it is the power valves. Just a thought.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| this is a saver.... GM build codes | TooMany2count | General Rodding Tech | 24 | 11-23-2009 09:36 AM |
| Power! -- No power? -- Power!!!! No Power???! | Fragzem | Engine | 10 | 05-16-2005 01:30 PM |
| what stereo wires under carpet? | bullheimer | Electrical | 19 | 05-06-2005 06:37 PM |
| MSD offroad-6, MSD 8366 Distributor, Holley 950 ECU | izord | Electrical | 0 | 09-06-2004 02:16 PM |
| Holley Power Valve Question ? | Skully | Engine | 2 | 12-14-2003 03:40 PM |
