Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - How do I put on a starter brace on a 350 sbc?
View Single Post
  #1 (permalink)  
Old 05-18-2009, 06:01 PM
eric32 eric32 is offline
Registered User
 
Last photo:
Join Date: May 2008
Location: ohio
Posts: 1,309
Wiki Edits: 0

Thanks: 6
Thanked 33 Times in 31 Posts
How do I put on a starter brace on a 350 sbc?

Hello guys I have been reading about how your supposed to use a starter brace on 350 small block chevy. I currently have two trucks with 350's in them and neither one has a starter brace on them. The 86 s10 I have has a gear drive starter on it and my dad said I don't need one since it does not pull as hard as a torque drive starter. My other 96 s10 has a plain old torque starter and I don't want to risk damaging my new 350 to put in it this weekend. I will eventually get a gear drive for it when funds permit but for the time being I will use whats on it. But the question I have looking at a picture of one on summit's website I can't tell how it goes on. Any help or photos would be nice. Thanks for help guys.
Eric
Reply With Quote