Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - How hot do the A.I.R. tubes get?
View Single Post
  #5 (permalink)  
Old 01-22-2007, 04:54 PM
Ozz1967's Avatar
Ozz1967 Ozz1967 is offline
Air Force Guy
 
Last photo:
Join Date: Aug 2004
Location: Layton, Utah for now, somewhere else later.
Age: 37
Posts: 260
Wiki Edits: 0

Thanks: 0
Thanked 1 Time in 1 Post
It's for my 1984 Trans Am. I put headers on it and then arced one of my plug wires to the headers. So I bought a new rotor, cap and plug wires along with this sweet wire loom from Summit...only because my Headers are emission legal, and have the A.I.R. tubes, it don't fit. I routed the wires and no matter how I route them, there is some point where they are touching the tubes. This is especially prevelant on the drivers side, numbers 1 and 3 cylinders. It's not a show car by any means, I just want it to work right and not arc another plug wire two months down the road from insulation breakdown.
Reply With Quote