Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - how to make a rearend jig.
View Single Post
  #4 (permalink)  
Old 07-24-2011, 08:57 PM
zildjian4life218's Avatar
zildjian4life218 zildjian4life218 is offline
Listen and Learn
 
Last wiki edit: DIY junkyard electrical fan controller
Last journal entry: SBC 305 Twin Turbo
Last photo:
Join Date: Dec 2008
Location: WNY/Rochester, New York
Age: 25
Posts: 1,670
Wiki Edits: 7

Thanks: 44
Thanked 10 Times in 10 Posts
Can anyone give me some tips and pointers who have made jigs before... I figured I would take the 7.5" rear end and make the jig hold it on the center of the pinion flange and center of the axle flange... Then make brackets that bolt to all the control arm mounts.. Then when I set the ford 8.8 into place I can trim all the brackets until they fit the mounts i made.... Am I even close?
Reply With Quote