Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - How to sew an inset panel?
View Single Post
  #1 (permalink)  
Old 02-06-2011, 05:38 PM
mpm32 mpm32 is offline
Registered User
 
Last photo:
Join Date: Sep 2010
Location: CT
Posts: 23
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
How to sew an inset panel?

I made a tuck and roll panel that I would like to inset into a panel. I tried to make a test piece, I traced the tuck and roll panel, then I drew lines toward the inside the width of my seam allowance. I then tried to sew it to the tuck and roll piece. I'm having trouble getting the corners to lay flat.

How do you sew this?

I'm trying to replicate the lines that were heat stamped into the original vinyl on my boat.
Reply With Quote