|
|
|
03-03-2012, 07:17 PM
|
||||
|
||||
|
hydralic clutch
i have built a 48 f-1 ford truck with a small block chevt and a t-5 trans out of a 3rd gen camaro. it works great, except i cannot get the clearance ( 1/8 to 3/16) clearance between the presure plate and throw out bearing. any ideas?
|
|
03-03-2012, 07:59 PM
|
||||
|
||||
|
Wrong bell housing? Wrong pressure plate? Wrong clutch fork? Wrong throwout bearing? Wrong pivot ball in the bell housing? Not enough travel in the slave and/or master cylinder?
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hydralic clutch troubles | chevy mikee | Transmission - Rearend | 1 | 12-30-2011 01:13 PM |
| ned help with hydralic clutch conversion | 36int | Transmission - Rearend | 2 | 01-03-2011 01:29 PM |
| hydralic pressure basics?? | oldguy829 | Suspension - Brakes - Steering | 10 | 09-25-2006 10:19 AM |
| hydralic or solid? | Echofive | Engine | 5 | 03-19-2004 05:13 PM |
| Hydralic Clutch on a nova? | buntdeer | Transmission - Rearend | 1 | 01-14-2004 04:56 PM |
