Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Hydraulic Lifters
View Single Post
  #4 (permalink)  
Old 02-18-2004, 03:01 PM
Vista Cruiser's Avatar
Vista Cruiser Vista Cruiser is offline
New Member
Join Date: Jan 2004
Location: Wichita, KS
Posts: 25
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Thanks for the reply, I was kinda worried about over tightening the valves when I did this. But after the adjustment the car started and idled fine with throttle. Plus, the car seems to run better than ever.
Comp cams recommends 1/2 to 3/4 turns static, Crane recommends 1/2 to one full turn. It obviously is not holding the valves open, but to my orignal question, do I get more lift?


Thanks guys,

So I am just pushing my pushrod down further into my lifter, and the running better is all in my head. Wouldn't be the first time.

Thanks again


Last edited by Vista Cruiser; 02-18-2004 at 03:01 PM.
Reply With Quote