|
I'm not ready to give up just yet. Last night I tried a "0" tip and stuck it through the antenna hole. Heat cool, heat cool a couple times. I'll try again tonight. It seems like there is sheet metal around the nut from that angle but I'll check again tonight. I'm working on the pass. side and being right handed, it's a little awkward swinging the hammer without missing! ouch! I haven't missed yet but I did take a stupid fall when my vise grips slipped while pulling on the metal around the tail light trying to pull out a small dent! I know, that's why I called it a stupid fall! I grabbed the slide hammer after that. I did get a nice bruise where I fell into my grinder stand though. Dumb A**! Are all impact drivers created equal?
|