Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Ideas on how to get the phillips screws out?
View Single Post
  #21 (permalink)  
Old 09-14-2012, 03:17 PM
hinges56's Avatar
hinges56 hinges56 is offline
Registered User
 
Last photo:
Join Date: Nov 2011
Location: Canyon Lake, Ca.
Age: 62
Posts: 70
Wiki Edits: 0

Thanks: 47
Thanked 1 Time in 1 Post
Once again, with everyone's help, the job gets done! Heating and cooling the head did it! I would have figured that doing this would have softened the head and then stripped out with the impact driver but not so. Also under the head is a mean star lock washer that was actually sunk into the metal. I think the the head end was more "froze up" than the thread end like I originally thought and a whole lot easier to get to. Thanks again for all the help!
Reply With Quote