Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - IFS for model a
Thread: IFS for model a
View Single Post
  #2 (permalink)  
Old 08-23-2002, 05:48 PM
willys36@aol.com's Avatar
willys36@aol.com willys36@aol.com is offline
Hotrodders.com Moderator
 
Last wiki edit: How to rebuild a Rochester Quadrajet 4MV carbureto...
Last journal entry: How to change auto shift timing on 200R4
Last photo:
Join Date: May 2002
Location: Bakersfield
Posts: 8,384
Wiki Edits: 21

Thanks: 1
Thanked 4 Times in 4 Posts
Post

Don't seem to be getting any action on this so I will throw in a couple of cents. I have seen magazine articles on this installation and it can be done. One problem with this body style is that you will need to put a couple of fairly large bubbles in the front fenders to clear the upper A-arms, especially if you want it in the weeds. I personally don't like the look but then there isn't much about Fords that I do like! I'm sure the aftermarket MII x-member suppliers have directions on how to make the installation. Probably can do a Yahoo search and find a web page that shows how also.
Reply With Quote