Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Installed new reman'd Edelbrock carb... can't get engine to run!
View Single Post
  #3 (permalink)  
Old 06-22-2008, 02:38 PM
MyHooptie MyHooptie is offline
Registered User
 
Join Date: Jun 2008
Location: Vancouver BC
Posts: 14
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Hmmm... gave the carb a gentle beating ...

Still acting the same so I pulled it off to find the inside on my intake drenched in gas. I pulled the top off the carb and carefully lifted the top) hoping to catch one of the floats sticking but both seem to be loose and moving freely. I did as described in their vid and flipped the top and checked the floats gap. Pretty damn close to 7/16".

Is there something else I should be checking while I have the carb open?
Reply With Quote