Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Installed new reman'd Edelbrock carb... can't get engine to run!
View Single Post
  #8 (permalink)  
Old 06-22-2008, 05:13 PM
MyHooptie MyHooptie is offline
Registered User
 
Join Date: Jun 2008
Location: Vancouver BC
Posts: 14
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
I took the carb off before opening it up and prob lost some of the fuel that was in its bowls but even still the levels were quite high. My guess is with the floats in there it would prob be to its top. Don't recall if there was much for gas at the accelerator pump. I did previously check the fuel pump and its def moving gas... alot of gas it seems. With the end of the fuel line in an old spaghetti sauce jar, a few rotations had the jar half full of gas.
Reply With Quote