|
|
|
01-07-2002, 11:50 AM
|
|||||
|
|||||
Installing an inner wheel house
I'm in the process of replacing my RH rear quarter and outer wheel house on my 1968 Mustang convertible. I found that the inner house has to be replaced also. The inner house has a flat on the top section, I would beleive thats for space when the is down. The after market piece doesn't have the flat. Does anyone know if I can get away with installing the house as is with the rounded top. Any info on this one would be really appreciated.
|
|
01-07-2002, 05:45 PM
|
||||
|
||||
|
I don't know much about Mustanges or convertables but I was just wondering - could you cut out the shape on the top of the wheel well and weld in a piece of flat metal ?
|
|
01-08-2002, 05:44 AM
|
|||||
|
|||||
|
That seems to be the way I'll be going with this one. The more I look at it, I'll need that clearance for the top. Thanks for the response Bear, Joe.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ford Steel Wheel Tech | wheelkid | General Rodding Tech | 9 | 01-07-2007 06:31 PM |
| What wheel wrench | fat40 | General Rodding Tech | 16 | 07-17-2006 05:34 AM |
| Spindle interchanges | bskaggs | Suspension - Brakes - Steering | 11 | 06-05-2006 01:29 PM |
| Early Ford Wire Wheel Tech | wheelkid | General Rodding Tech | 1 | 06-02-2006 12:15 AM |
| Steering Wheel Adapters Question | horvath | Interior | 17 | 06-26-2004 06:50 PM |
