Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - installing motor with aluminum heads
View Single Post
  #3 (permalink)  
Old 06-04-2003, 08:12 PM
Bumpstick's Avatar
Bumpstick Bumpstick is offline
Hammer and a torch
 
Last photo:
Join Date: May 2003
Location: Southeast TX
Age: 54
Posts: 1,258
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Post

My preference is to use a carb plate... Just have the intake installed and it bolts were the carb sits... They are simple and have multiple holes to allow for balance and spread the tension out over a large area...
Reply With Quote