Hot Rod Forum : Hotrodders Bulletin Board

Hot Rod Forum : Hotrodders Bulletin Board (http://www.hotrodders.com/forum/)
-   General Rodding Tech (http://www.hotrodders.com/forum/general-rodding-tech/)
-   -   installing power windows (http://www.hotrodders.com/forum/installing-power-windows-30797.html)

stanjr41 12-23-2003 04:10 PM

installing power windows
 
I have a 1965 AMC Rambler American 330 station wagon that I want to install power windows in. (4 doors)All the kits I have seen need either flat glass(mine is slightly curved) or fits over the crank handle and is seen inside the car.I remember reading an article in Street Rodder a few years ago about a guy who would take the original regulator and convert it to power. This would be the best, but I'm open to suggestions. Thanks;Stan

302 Z28 12-23-2003 07:27 PM

Specialty Power Windows.

http://www.specialtypowerwindows.com/home.htm

Vince

tm454 12-29-2003 01:32 PM

Elect windows
 
Thanks to Z-man I too have the information for future reference.


Tazz
trolloligest


Rat Rods Rule!

Deuce 12-29-2003 05:44 PM

:D


Nu Relics Power Windows
6621 Old Hwy 421
East Bend NC 27018

336-699-8949

They MAY be the folks you were speaking of.

They take your old AMC regulators (from your vehicle) and convert them to power.

They did not make universal kits :spank:
They simply convert yours to power.



DEUCE

ianhealey 12-29-2003 07:32 PM

mmm pwr
 
i read a great artical on prw windows
a while back the guy got 4 donor doors and cut out the iners
reg switch and motor he had to muck around to fiit up to his glass
and bailey channel tacked it in the checked and welded it
it sounded so simple it did have a drawback he ended up moving the switch to fit the arm rest


All times are GMT -6. The time now is 12:40 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.