Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - intake bolts not lining up
View Single Post
  #1 (permalink)  
Old 01-27-2012, 10:05 PM
sam_bo3 sam_bo3 is offline
Registered User
 
Last photo:
Join Date: Nov 2003
Location: oklahoma
Age: 33
Posts: 250
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
intake bolts not lining up

I finally got my RHS aluminum heads that were ported and milled on my 355. I'm not sure how much was taken off. They went from 64cc chambers to 61. I also had a weiland stealth(their version of performer RPM) non-vortecintake port matched. I ordered from negs w/ install kit (bolts and gaskets). The gaskets are cheap paper jegs brand. The right side lined up perfect. The left is 1/16 or 1/8 of an in off letting the bolts line up. Should willow the holes out? Could it be the gaskets? Do should they have trimmed the intake to fit the milled heads?
Reply With Quote