Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - intake bolts not lining up
View Single Post
  #4 (permalink)  
Old 01-28-2012, 01:21 AM
SSedan64's Avatar
SSedan64 SSedan64 is offline
Registered User
 
Last photo:
Join Date: Dec 2007
Location: Macon, GA.
Age: 50
Posts: 6,016
Wiki Edits: 0

Thanks: 0
Thanked 46 Times in 46 Posts
Normally .006" cut per cc. so .018" cut = 3cc. Flat Milling.
.0075" per cc. when Angle Milling.
I would think they would've machined both for proper alignment.
Reply With Quote