|
|
|
08-02-2002, 04:12 AM
|
||||||
|
||||||
Internal vs External
I have a stock GM HEI distributor, and plan to install a MSD 6AL ignition, and cap, rotor. Should I go with an internal coil and module, or use an external coil ? What's better and why? Thanks in advance for any info. Car runs the 1/4 -108mph @12.6 with street tires.
|
|
08-02-2002, 02:07 PM
|
||||||
|
||||||
I would go with the external coil, the MSD Blaster 3 power tower. I have had problems with the internal MSD and Accel,a little more $ to do this but worth the money.
|
|
08-05-2002, 04:39 AM
|
||||||
|
||||||
Thanks Roys63. I'm kinda disappointed you were the only reply I got, but everyone I've talked to says external is the way to go due to the heat factor. I hope their all right, it's a lot of $$$ to set up.
|
|
08-05-2002, 08:11 AM
|
||||||
|
||||||
|
Dollybud, in general if you receive only one reply the consensus is that answer is the correct one, many do as I do and don't reply if someone else has answered the question correctly.
__________________
Outlawed tunes from outlawed pipes
|
|
08-05-2002, 06:48 PM
|
||||||
|
||||||
Thanks 4 Jaw Chuck, as you can see I'm still learning something from these posts everyday. Thanks again for enlightening me, greatly appreciated.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
