Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Iron Duke stroker kits?
View Single Post
  #15 (permalink)  
Old 04-05-2006, 09:13 AM
KSGerry KSGerry is offline
New Member
 
Last photo:
Join Date: Feb 2003
Location: Chapman, Kansas U.S.A.
Posts: 28
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Kansas Racing Products, http://www.kansasracingproducts.com

An inline four cylinder block based on the Pontiac Superduty-4 engine. It will accept all of the Pontiac SD-4 components. Also, the block can be ordered to be finish-machined to accept virtually any smallblock V-8 cylinder head...GM, Ford or Mopar. Displacements from 140 cid to 213 cid...up to a four inch stroke crankshaft and 4.125 inch cylinder bore. Roller camshafts are supported by five journal roller bearings. Bellhousing parttern can be ordered to accept most common bellhousings.

A KRP engine has never suffered a block-related failure even under high boost conditions!!
Reply With Quote