Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Issue with New Jet Drill Press...
View Single Post
  #1 (permalink)  
Old 12-29-2007, 12:18 PM
71gtx 71gtx is offline
Member
 

Last journal entry: Rear End Disassembly
Last photo:
Join Date: Sep 2003
Location: chicago, IL
Age: 27
Posts: 441
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Issue with New Jet Drill Press...

I recently purchased a 16.5" jet drill press. I got to the end of the assembly and I noticed that the arbor would not go down fully into the chuck. Upon putting the arbor and chuck into the spindle, I turned it on and had a large wobble in the chuck. The bearing seems fine, but as I look into the open end of the chuck, I can see that the arbor hasn't reached the mating surface that it should meet. I took the machine back, got another and had the same problem. Any suggestions?
Reply With Quote