Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
hotrodders.com: Project Journals: S10xGN's Journal
User Name
Password
lost password?   |   register now

View S10xGN's profile Entries: 38
Views: 10057
view from the beginning || now viewing most recent entries


Pages (8): [1] 2 3 4 5 6 7 8

02-18-2008 06:58 PM Body on Frame today.
Creative use of the engine crane, I used it to lift the body off the rotissiere and push it over the frame. Rear wheels install just fine *if* the car is raised enough to roll the wheel under it, yes a floor jack will get it high enough.


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #38]

02-06-2008 08:25 PM Ankle Biters
AKA running board mounts.


(click photo to enlarge)

(click photo to enlarge)
  [Entry #37]

02-06-2008 08:24 PM Engine & trans in place
Got the '03 Corvette LS-1 & 200R4 from an '85 MCSS set in place today. The oil pan is from a CTSV. The A/C is a low-pass mount setup from S&P (the only way to fit air down low). Also got the "ankle biters" installed, but will need new bolts. She's got 6" ground clearance under the front X-mem & 4.5" under the pan.


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #36]

02-05-2008 04:40 PM Finshed frame!
Now a roller!


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #35]

02-05-2008 04:38 PM Frame being assembled!
A few pix of the finish (Hammerite Silver) and frame being assembled. Let's see... epoxy on Saturday, Hammerite on Sunday, assembly on Monday. Wish I could work that fast all the time!


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #34]

Pages (8): [1] 2 3 4 5 6 7 8


All times are GMT -6. The time now is 02:55 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.