Hotrodders Bulletin Board - Journal

Hotrodders Project Journals
Home Page · Bulletin Board · Project Journals · Tech Article Wiki · Project Journal Archives · Knowledge Base · Photo Gallery · Classifieds · Company Reviews · T-Shirts

We wrote an article exposing a kit-car company called Streetbeasts.

Now, they've tried to silence us with a frivolous lawsuit.

Guess what happens when unethical companies try to bully hotrodders out of their free speech?
Get the details, and see how you can lend a hand.

Hotrodders Bulletin Board > Journal > matt167's Journal

Entries: 9
Views: 491

view from the beginning || now viewing most recent entries

Pages (2): [1] 2 »

11-21-2009 09:40 PM

Firewall's on the Frame

Here is the firewall. the frame was drilled and tapped, and the bottom rail I welded on the firewall was drilled, and it's simply bolted..

(click photo to enlarge)

[Entry #9]

11-17-2009 11:33 PM

worked on the firewall a little more

Firewall is nearly finished. I did cut 6" off of it, which brought it down to 33" at the crown.. 1"x1" 16 gauge square tubing was welded to the bottom edge of the inside of the firewall. it is the beginnings of the bottom part of the body framework, and the frame will get drilled and tapped, and the framework will get bolted to the frame.

(click photo to enlarge)

[Entry #8]

11-16-2009 12:47 AM

Worked on the firewall today

drew the pattern and cut the firewall out today.. it's a simple design done by using a peice of moulding like a divider and drawing a 1/2 moon.. because the body will be the full 48" wide the full length. the cowl and firewall are the complete 48" wide, this will aid in room and comfort... the firewall is quite tall in the center. 39" to the top, and it's just over 30" tall on the sides. I might shorten it a little from the bottom

(click photo to enlarge)

[Entry #7]

11-07-2009 12:03 AM

Frame almost finished

got the perches on, and finished up the welds. just needs a slight bit more work b4 I call it done

(click photo to enlarge)

[Entry #6]

11-03-2009 11:10 PM

Frames togther

Squared up the frame and welded it togther.. blew up 2 high quality hole saw mandrels cutting out for the front tube, but I got it togther..

(click photo to enlarge)

[Entry #5]

Pages (2): [1] 2 »