Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
hotrodders.com: Project Journals: 31fordcoupe's Journal
User Name
Password
lost password?   |   register now

View 31fordcoupe's profile Entries: 9
Views: 2263
view from the beginning || now viewing most recent entries


Pages (2): [1] 2

01-17-2010 10:16 PM Gunked up 454 water jacket
This is the picture of the rear drivers side water jacket after pulling the intake. I just bought this motor and pulled the intake and this is what I found. It was caked at the surface and after digging out all the gunk (which felt like sand, and oil and tooth paste mixed together), it cleaned up real well. The gunk only went down about 1/2 inch.


(click photo to enlarge)
  [Entry #10]

01-17-2010 10:12 PM 454 Intake Coolant Jackets
Take a look at these guys. What would cause the rear water jackets to get all blocked up like this? Guessing bad seal on rear of intake? Front water jackets were clean as a whistle (this picture).


(click photo to enlarge)
  [Entry #9]

07-26-2009 10:03 PM 9 inch cut down continued
one more photo


(click photo to enlarge)
  [Entry #8]

07-26-2009 10:03 PM 9 inch cut down continued
Additional photos


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #7]

07-26-2009 09:58 PM 9 inch cut down
This is what I am starting with. Going from a 28 spline axle non posi to a 31 spline axle and 3.89 posi.


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #6]

Pages (2): [1] 2


All times are GMT -6. The time now is 11:59 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.