Hotrodders Bulletin Board - Journal

Hotrodders Project Journals
Home Page · Bulletin Board · Project Journals · Tech Article Wiki · Project Journal Archives · Knowledge Base · Photo Gallery · Classifieds · Company Reviews · T-Shirts

We wrote an article exposing a kit-car company called Streetbeasts.

Now, they've tried to silence us with a frivolous lawsuit.

Guess what happens when unethical companies try to bully hotrodders out of their free speech?
Get the details, and see how you can lend a hand.

Hotrodders Bulletin Board > Journal > stuartc's Journal

Entries: 9
Views: 1125

view from the beginning || now viewing most recent entries

Pages (2): [1] 2 »

07-10-2007 04:36 PM

The floor going in

This is the floor and trans tunnel going in

(click photo to enlarge)

[Entry #9]

09-09-2005 09:17 AM

dash board pannel

I did have a fiber glass replacement dash board because the one that was in the car had be cut around buy the previous owner.But i bought anther Anglia so i could get some parts off it and i looked at the dash board panel and it looked good.I have filled the clock holes that i don't need and have fitted my gages into it and this will be fitted after the fire wall has gone in.

(click photo to enlarge)

[Entry #8]

09-09-2005 09:05 AM

inner wings

These are some panels I have made up to fill the inner wing area to add a little strength and to make it look a little better.

(click photo to enlarge)

[Entry #7]

03-22-2005 05:20 PM

pannel work

I have come to the stage of putting the firewall in and the floor pans in.It took me a while to figure out how to make a template of these areas in the end i used card to give me the inner edge of the pannels i needed to make and now I am converting them into steel

(click photo to enlarge)

[Entry #6]

01-07-2005 03:51 PM

the engine mount

well things have been going well the engine and the gear box are now fixed into the car.The mounts took a while to make and adjust and get them how i wanted them but itis done now.all the mount have been made so they can be unbolted to make it easeir if the engine or gearbox have to come out

(click photo to enlarge)

[Entry #5]

Pages (2): [1] 2 »