I have this going in a thread under the engine forum but seems like it would be better suited here. I am building a twin turbo low rpm max torque twin turbo motor. It will have two T25 turbos with a reline of 5000rpm. I plan to make gobs of torque from idle to 5000 rpm. As of now I have the short block together. Just waiting to get more money together to buy the cam.
Here are the specs:
Stock disk piston 305
882 heads
7.5:1 cr
tpi fuel injected intake with mega squirt
summit 1069 cam http://www.summitracing.com/parts/SUM-1069/
ring gap is:
1st. .028
2nd .030
Okay I finally had some extra time this past weekend and decided to put a cam in the motor. This weekend ill get the oil pan bolted down, lap the valves, and bolt them down and maybe get the valves all set and get it ready to fire on the stand. I also did finally find a second identical match for the one saab turbo I have so hopefully I can get some flanges and bust out the welder and start making some manifolds!
(click photo to enlarge)
| 
(click photo to enlarge)
|
|
|
|
All times are GMT -6. The time now is 03:49 AM.
)
)