Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
hotrodders.com: Project Journals: renegade6's Journal
User Name
Password
lost password?   |   register now

View renegade6's profile Entries: 8
Views: 440
view from the beginning || now viewing most recent entries


Pages (2): [1] 2

04-24-2013 04:22 PM Front Bumper--Filling it in
Cut the brackets off and put an 11 gauge piece of sheet metal that I had bent to match the bend in the bumper. Welded it from the back and still have to finish up filling in a few gaps.


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #8]

04-23-2013 07:20 PM Finishing the dash and trim holes
Filled the rest of the holes in the dash as well as the grill for the speaker in the dash.

Finished all of the trim holes that I'm going to do on the rest of the body and fixed a dent on the rear quarter. I think I still have a high spot that I will have to shrink down but, a lot better than it was.


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #7]

04-23-2013 07:18 PM Filling in dash holes
Self explanatory.

Filling in the hole for the vent control was interesting as it has a curve that bends inwards towards the steering column.


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #6]

04-23-2013 07:16 PM Hole filling
Time to continue with the tear down and fill some unnecessary holes.

While I was chipping away at some bondo, I discovered that I'm probably going to have to replace the passenger side B pillar and put in a quarter panel patch.


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #5]

04-23-2013 07:14 PM The car is back and time to start tearing it down
I finally got it back in February and decided to start tearing it down and get on with the bodywork. Since I had a bit of time, I figured I would start with the bumpers.

The front was fairly easy to make into a one-piece and tuck it in but, the back is a work in progress.


(click photo to enlarge)

(click photo to enlarge)

(click photo to enlarge)
  [Entry #4]

Pages (2): [1] 2


All times are GMT -6. The time now is 03:12 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.