Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Lathe Identification and general info?
Thread: Lathe Identification and general info?
View Single Post
  #5 (permalink)  
Old 04-28-2009, 05:33 PM
cgates cgates is offline
Registered User
  
Join Date: Aug 2005
Location: Florida
Posts: 36
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
That looks a lot like an old C A Clausing that I had. Probably pre war. Mine was a flat belt drive. Not real good for precision part but to learn on, not too bad.
Reply With Quote