Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Leblond metal lathe advice?
View Single Post
  #20 (permalink)  
Old 10-05-2005, 12:27 PM
grouch's Avatar
grouch grouch is offline
Registered User
 
Last wiki edit: How to document your project
Last journal entry: 1949 Olds -- Rotisserie, pt. 9
Last photo:
Join Date: Jul 2004
Location: KY
Posts: 1,143
Wiki Edits: 2

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by snod83
This sounds interesting, do you have a link to more information on this multimachine?

Thanks,
Ryan
multimachine -- DIY open source machining

Quite a bit has taken place in the yahoo group messages (link in first post of thread above) since that thread, so check both.
Reply With Quote