Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Looking for Someone in So. Cal Who Can "Teach" Me Machining on My Machine
View Single Post
  #16 (permalink)  
Old 12-28-2012, 07:54 PM
toddalin toddalin is offline
Registered User
 
Last photo:
Join Date: Apr 2012
Posts: 140
Wiki Edits: 0

Thanks: 1
Thanked 10 Times in 10 Posts
The controller is housed within the sheetmetal just below the "angle." I didn't get the manual nor the software with it. Will probably need to get hold of mfg or someone who has one to get the pin assignments.



I will take you up on those G-codes.
Reply With Quote