|
|
|
10-14-2007, 11:24 AM
|
||||
|
||||
|
lowering 53 chevy pu
just joined and have a question.don't think i want to do a front crossmember on a very original truck.found a 3 inch drop axle and 3 inch drop springs,would like to do both in the front.any reason why it wouldn't work and drive decent?i also bought 600 16 bias tires,would radials have made much of a difference in handling on this truck because i wanted to stay original.thanks.
|
|
10-16-2007, 09:05 AM
|
||||||
|
||||||
|
Should work fine. That is a lot of drop so check clearances but otherwise should be as good as stock.
|
|
10-16-2007, 03:57 PM
|
||||
|
||||
|
thanks willys36,talked to someone else and they pretty much said the same thing.think i'll give it a shot,thanks.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine build ideas | Rug | Engine | 23 | 12-25-2006 01:39 PM |
| 53 Chevy PU Lowering | Chevy535 | Hotrodding Basics | 2 | 07-20-2006 04:56 PM |
| '53 Chevy stepside. | DazC | General Rodding Tech | 4 | 09-05-2004 07:47 AM |
| Rear gas tank conversion on 80 chevy pu | williambartram | General Rodding Tech | 5 | 09-18-2003 11:21 AM |
| caddy 1/4's on 53 chevy | jeffs53? | Body - Exterior | 3 | 01-19-2003 07:35 PM |
