Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - LT1 rotating assy into a Vortec 5.7 block opinions
View Single Post
  #1 (permalink)  
Old 02-06-2012, 10:39 AM
Jim Rockford's Avatar
Jim Rockford Jim Rockford is offline
World Famous VF-14
 

Last journal entry: Cleaned it up...
Last photo:
Join Date: Dec 2008
Location: Virginia
Age: 43
Posts: 411
Wiki Edits: 0

Thanks: 10
Thanked 0 Times in 0 Posts
LT1 rotating assy into a Vortec 5.7 block opinions

Just picked up a(nother) sweet 77 impala coupe. has a decent running 305 2 brl engine in it now,but I'm looking do do a budget 350 i have a vortec 350 short block that has a bad bottom end, haven't pulled the pan yet to see if It can be saved, but I also have a very low mileage lt1 that came out of a road master with an electrical fire, few burn sensors , but that all, wondering about installing the pistons rods and crank into the vortec block and topping it with a set of l98 heads I have laying around and a used edelbrock performer .. What do you guys think...?
any thoughts on a good roller cam?
Reply With Quote