Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - LT1 rotating assy into a Vortec 5.7 block opinions
View Single Post
  #14 (permalink)  
Old 02-08-2012, 09:53 AM
Jim Rockford's Avatar
Jim Rockford Jim Rockford is offline
World Famous VF-14
 

Last journal entry: Cleaned it up...
Last photo:
Join Date: Dec 2008
Location: Virginia
Age: 42
Posts: 411
Wiki Edits: 0

Thanks: 10
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by onlyfnway
If i am not mistaken the lt1 cam does not have a gear for the dist. being it is driven off the front of the engine. Lt1 heads should be 58cc?
You are thinking of the LS series engines,,
the LT1 has a stuby shaft that sits under the intake

Quote:
Originally Posted by louis165
Jim you wouldn't by any chance know the cc of the vortec dish piston would you?
What I found on the Interwebs..
Quote:
I measured the dish and found that they are 10.5 CCs, and they are .028" in the hole. I was trying to decide if not changing pistons was going to cost me too much power vs. how much money it would cost to change them.
Reply With Quote