Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - LT1 rotating assy into a Vortec 5.7 block opinions
View Single Post
  #25 (permalink)  
Old 03-27-2012, 06:39 AM
Jim Rockford's Avatar
Jim Rockford Jim Rockford is offline
World Famous VF-14

Last journal entry: Cleaned it up...
Last photo:
Join Date: Dec 2008
Location: Temple,Tx
Age: 45
Posts: 427
Wiki Edits: 0

Thanks: 12
Thanked 4 Times in 4 Posts
Originally Posted by Jim Rockford
Just picked up a(nother) sweet 77 impala coupe. has a decent running 305 2 brl engine in it now,but I'm looking do do a budget 350 i have a vortec 350 short block that has a bad bottom end, haven't pulled the pan yet to see if It can be saved, but I also have a very low mileage lt1 that came out of a road master with an electrical fire, few burn sensors , but that all, wondering about installing the pistons rods and crank into the vortec block and topping it with a set of l98 heads I have laying around and a used edelbrock performer .. What do you guys think...?
any thoughts on a good roller cam?

Why is my thread in Hotrodding basics It should be in the engine section... please move it .
Reply With Quote