Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Manualy operated kickdown pedal idea.
View Single Post
  #1 (permalink)  
Old 01-29-2004, 07:13 PM
powerwagon powerwagon is offline
Registered User
 
Join Date: Oct 2003
Age: 36
Posts: 5
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Manualy operated kickdown pedal idea.

So I just got through installing a Weland manifold and two barrel holley on my dodge W150 with a 318 motor and NP203 tranny. Now, due to the fact that the Action Plus manifold places the carb a few inches higher, the stock kickdown linkage is to short to reach the side of the carb. I was thinking of all the ways to elongate it to fit when I came up with this idea:

Connect some kind of pull cable (throttle cable, mountain bike brake cable, twine, etc) to the lever on the tranny, and the other end to a small pedal about where a clutch would be.

This would theoretically give me infinite control over when it downshifts, right? Is there some key piece of information about kickdowns that I am missing here, or would this work flawlessly?
Reply With Quote