Hot Rod Forum : Hotrodders Bulletin Board - View Profile: cboy -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board
User Name
lost password?   |   register now

cboy cboy is offline


Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. Stango289
    10-30-2015 11:46 AM - permalink
    Hi, I was taking a look at the square tubing mod you made for the tube bender. I have the same type bender and would like to purchase one of the die and roller from you. How much?
  2. dinger
    04-14-2014 01:11 AM - permalink
    Dewey, How are you doing? I may be in your neck of the woods soon for my job, would love to buy you lunch. Dan
  3. cboy
    12-08-2013 05:01 PM - permalink
    Just Old,

    I owe you a huge apology for not responding to your question. It got totally lost in my notification box. Sorry about that. If you are still looking at using a twin I beam front end, I found that making the frame rails 32" wide (measured outside to outside) works well and then plac3 the axle pivot mount holes directly over the frame rail. (works on axles up to 79, later axles require different mounting positions). Hope that helps a bit. Again, sorry for the delay.

    08-23-2013 02:16 PM - permalink
    are there any standard measurements I should follow on the frame build . and is there any measurements when some one uses the twin I beam type front end . I did not no if the book shows dimision on it .
    thank you

About Me


Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 10-19-2015 01:34 PM
  • Join Date: 01-22-2004


Showing Friends 1 to 4 of 4

All times are GMT -6. The time now is 08:34 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright 1999 - 2012. All Rights Reserved.