Hot Rod Forum : Hotrodders Bulletin Board - View Profile: Rexy2002 -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board
User Name
lost password?   |   register now

Rexy2002 Rexy2002 is offline

Registered User

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. Rexy2002
    07-01-2014 05:13 PM - permalink
    I like the HVLP cap the better than the lvlp and the 1.4mm tip. I set mine at 30psi at the gun, 35psi works fine too if i want to move faster, fluid wide open and fan wide open as well. To get a smaller pattern just move in closer to the surface. This gun sprays like an iwata and gets its high rate of transfer from high atomization and staying close to the surface. For me 4"-6" work best and medium speed passes, it seems with this gun the farther I get from the surface the more overspray I get, it works good close up.
  2. rodneypierce
    02-24-2014 05:59 PM - permalink
    Hey when you get a chance, check your PM's. I ended up getting a Warwick 904HE but not sure which cap to get for the gun, nor where to start for settings. I sprayed clear yesterday with it and it was not bad, but had a ton of overspray, and I had to move pretty slow to get it to lay out nice and smooth. I was using a 4:1 clear unreduced with 25 psi at the gun measured via the gauge supplied. Fluid control all the way out, and pattern adjusted to about 10 inches at 8 inches away


Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 03-22-2015 06:22 PM
  • Join Date: 05-11-2013

All times are GMT -6. The time now is 05:51 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.