Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Metalforming Louvers?
View Single Post
  #4 (permalink)  
Old 02-21-2004, 01:43 PM
BOBCRMAN@aol.com's Avatar
BOBCRMAN@aol.com BOBCRMAN@aol.com is online now
Member
 
Last photo:
Join Date: May 2002
Location: Holly, michigan
Posts: 8,236
Wiki Edits: 0

Thanks: 30
Thanked 296 Times in 276 Posts
Somewhere in the shop I have dies for a traditional 6" louvre. The dies are of course male and female and fit in a hydraulic single arm press (metalworker). You can get an idea of how a louvre press works by checking out this site www.metalshapers.org
Reply With Quote