Welcome To Hotrodders
Tech Help
General Hot Rod Forum Discussions
Knowledge Base
Marketplace
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
Will vortec heads from a 880 Chevy 350 be used on a 638 Chevy 350. Bolt patterns match perfectly. What are the pros n cons.2 replies 54 views
-
What's your favorite oil filter I've cut some open and they seemed to very similar maybe thicker paper. The two on left 22RE and my 94 Chevy 350 with oil cooler the two on right. Old school SBC. LUBER FINER has a flat top the outher are domed. What's with the square or round holes? Dose anyone...17 replies 346 views
-
Our old family mini van. 2000 Ford Windstar 3.6L The starter on it died. I confirmed. I bought the cheapest starter I could find. The first time I went to start the van, a horrible grinding sound came out. Its obviously the starter gear on the fly wheel. I thought I did something wrong...8 replies 84 views
-
1950 Ford Shoebox Resto-Rod I need to cut out a section of my trunk floor about 12"x12" to gain access to replace the fuel tank sending unit, which is on the top. This is a custom car and the previous owner/builder tack welded a bracket from the tank to the body. So dropping the tank is not...3 replies 53 views
-
I needed taller rocker covers to clear full roller rocker arms I installed. I was planning to run the stock accessory drive from a 94 B body LT1. This is a serpentine belt system. The Alternator won’t clear the new rocker covers so I’m designing my own accessory drive system to run power...5 replies 129 views