Welcome To Hotrodders
Tech Help
General Hot Rod Forum Discussions
Knowledge Base
Marketplace
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
Hi! I bought this cheap Super 7 build with a SBC V8 383 stroker that im fixing up. Its seems to run ok but some idiot have carved some stuff on the valve covers. What you guys think would be best to do? Would a good clean and use welding rods as filler work?(any risk to warp them?) Or 2k filler...3 replies 81 views
-
Hello everyone...... Im planning on building a 496 to replace the 402 in my 72 Monte Carlo. What I have so far is a bare gen IV block (standard bore), and a pair of 049 heads. The heads are being modified now with bigger valves, etc, and are about 112-113 cc's and will end up about 110. As...3 replies 97 views
-
Hi everyone I have a old Datsun I put a SBC into and once I was ready to start it I found out I'm not getting a spark out the plug wires, the distributor is an HEI and it does rotate and if I take the coil wire off the distributor and hold it close to ground I get spark but once I reconnect the...9 replies 112 views
-
I'm replacing the turbo 350 with a 4L60E in the '32 Ford highboy roadster. The engine is a stock 1994 LT1, rear end is 1999 Explorer Trac-Loc with 3.73 gears. tires are 28" tall. I estimate the car to weigh about 2200 lbs. What stall converter do you thing I should use? Have answers from...5 replies 139 views
-
Looking for advice. I have a show car that if it sits in garage for 4 days to a week the battery dies. I have had it tested and battery shows fine. Can I mount a battery tender to the car somewhere and just plug it in when I park it to keep it charged. If so what has everyone else used and...2 replies 87 views