Welcome To Hotrodders
Tech Help
General Hot Rod Forum Discussions
Knowledge Base
Marketplace
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
I've been driving this car for a while and finally want to deal with the noisy lifters on the Chrysler 413 engine, basically this car an Hydraulic Lifter Adjustment that I want to do myself. And I'm not sure what the best way to do it is. Some say you should adjust each rocker when it's at its...1 reply 35 views
-
Got a 72 Nova that someone swapped a 350/350 into at some point. It's a 10 footer car that's really nothing special except that it's mine. I've had it since 2021 and I basically overhauled everything that I possibly could so far. It's riding on new suspension up front and out back, new...0 replies 8 views
-
1950 Ford Shoebox Resto-Rod I need to cut out a section of my trunk floor about 12"x12" to gain access to replace the fuel tank sending unit, which is on the top. This is a custom car and the previous owner/builder tack welded a bracket from the tank to the body. So dropping the tank is not...6 replies 101 views
-
Been looking around at the aftermarket MII IFS's and thinking about options. I've seen full kits ranging in price from $1200 to over $5000. I have also seen the parts and pieces, individually, going for much cheaper. Now I know that buying a full kit tends to be cheaper in the long run than the...10 replies 397 views
-
Will vortec heads from a 880 Chevy 350 be used on a 638 Chevy 350. Bolt patterns match perfectly. What are the pros n cons.2 replies 92 views