Welcome To Hotrodders
Tech Help
General Hot Rod Forum Discussions
Knowledge Base
Marketplace
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
If someone here lives in the area of Colorado where this is required and has some knowledge about it, I would appreciate in what you are able to share. My wife and I currently live in San Angelo, TX and it looks like due to health and other reasons, it's going to be the best for us to move to...37 replies 8K views
-
Hi Everyone, I'm new to the hot rodders forum. I have a 1929 Model A sedan rat rod. It has a 1989 Mustang 5.0, and 4 speed and the clutch and brake assembly are from the same car. I would like to upgrade to power brakes but it seems very tight under the cowel for the brake booster. I've seen...21 replies 355 views
-
I'm looking for some input on this combo for a 350 build. This is my first full engine build. I've done a good chunk of research and asking around to figure out the best combo of parts for my intentions, but based on the cost of all of this, I'd like to get as much insight as possible. Pics at...7 replies 130 views
-
This is a very specific question. First: 385cid sbc 10.3:1 aluminum ebay heads 224/228 cam, 110 lsa 107 icl 91 octane ethanol free gas timing at 32* all in Water temp at 190* The engine was broke in on a dyno and all went well. We gave a pull to check things out. At the end we shut it down and...7 replies 123 views
-
Hello guys I just recently took and had my Holley 80457 600 vacuum secondary carburetor and I originally had down leg boosters installed in the main body to replace the factory straight leg standard boosters. These boosters screw in as I bought a kit from All State carburetor and started off...2 replies 165 views